Ir para o conteúdo principal

Alterações no passo #6

Edição por Antti Immonen

Edição aprovada por Antti Immonen

Antes
Depois
Sem alteração

Linhas de Passo

[* black] This is the layer that spreads the backlight evenly around the LCD horizontally.
[* yellow] The backlight is emitted from the strip of LED's that all seem to have around 3volts voltage drop across the p-n-junctioneach LED. In total the backlight LED strip requires around 30 volts, probably16volts, supplied through a three-pin connector by a voltage booster of some sortsort of switching power source.
[* green] The sidesblack] Apparently, there are two separate ground rails and a common Vcc, each operating half of the layerLED strip. These are possibly prevent the light from light doesn't escapingconnected in parallel.
[* yellow] The backlight is emitted from the strip of LED's that all seem to have around 3volts voltage drop across the p-n-junctioneach LED. In total the backlight LED strip requires around 30 volts, probably16volts, supplied through a three-pin connector by a voltage booster of some sortsort of switching power source.
[* green] The sidesblack] Apparently, there are two separate ground rails and a common Vcc, each operating half of the layerLED strip. These are possibly prevent the light from light doesn't escapingconnected in parallel.
[* black] To see LOCA stains clearly, you need to be looking at the pieces from the correct angle (second picture).