Ir para o conteúdo principal

Alterações no passo #28

Edição por Jeff Suovanen

Edição aprovada por Jeff Suovanen

Antes
Depois
Sem alteração

Linhas de Passo

-[* black] Insert an opening pick underneath the logic board to break up the adhesive holding it in place.
+[* icon_caution] As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.
+[* black] Carefully insert an opening pick under the logic board, between the front-facing camera and the battery.
[* icon_note] Be sure to insert the pick ''over'' the the antenna cable that runs along the length of the battery.
+[* black] Slide the guitar pick toward the front-facing camera connector, and stop at the bend in the logic board.