Alterações no passo nº 5
Edição por Erik Romanski —
Edição aprovada por Erik Romanski
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Re-attach the bolts removed in Steps 2 and 3. Put each bolt into the correct location before tightening each bolt. |
|---|---|
| - | [* icon_note] If the bolt attaching the seat tightens too easily, it is not in the hole and rests above or below the wood of the seat |
| + | [* black] Re-attach the bolts removed in Steps 2 and 3. Put each bolt into the correct location before tightening each bolt. |
| + | [* icon_note] If the bolt attaching the seat tightens too easily, it is not in the hole and rests above or below the wood of the seat. This is what causes the tipping or dipping in the seat. |
| [* icon_note] When attaching the bolt for the back of the chair, insert a plastic washer between the wood of the chair leg and the wood of the chair back as shown. Without this washer, the two pieces will not sit flush. This allows the chair to shift and become slightly unstable. |