Alterações no passo #4
Edição por Jake Devincenzi —
- Antes
- Depois
- Sem alteração
Linhas de Passo
| [* black] Place the leads of the resistor through the holes on either side of the rectangle marked R1 on the circuit board. [* icon_note] It does not matter which end faces which way when installing resistors. |
| [* black] Place the leads of the resistor through the holes on either side of the rectangle marked R1 on the circuit board. [* icon_note] It does not matter which end faces which way when installing resistors. |
| [* black] Turn the board over so that the copper leads are facing up and the resistor leads are pointing straight up in the air. |
| [* icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30^^o^^ down from vertical is acceptable. |