Alterações no passo nº 4
Edição por Zack McCauley —
Edição aprovada por Zack McCauley
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [title] Inserting the New Battery |
|---|---|
| + | [* green] Put the new battery over the holding posts and gently put the cable onto the connecter. Gently push on one side at a time as there are two clasps that keep the cable connected. You will hear two clicks when the cable is seated correctly. |
| + | [* black] Take the flat part of your spudger and carefully verify the cable is fully seated. |
| + | [* black] Once the cable is seated, put the four screws back in. This will secure the battery. |
| + | [* icon_note] Put the screws in loosely until all four are in place before tightening them down. |
Imagem 1
Nenhuma imagem anterior
Adicionado
Imagem 2
Nenhuma imagem anterior
Adicionado