Alterações no passo nº 5
Edição por Brian —
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] The next step will be to make the edge connector out of a scrap piece of PCB. | |
| [* black] I chose a section with ground plane on at least one side. It was sanded down to fit and scored to make 4 'traces'. | |
| [* black] The size of the traces almost matches a PCI connector. You might be able to scavenge a section from an old card. However, the traces leading away from the edge must travel straight together for a while so you have enough room for the cable for connect to them. | |
| - | [* black] I've ordered a prototype connector from [http://batchpcb.com/index.php/Home|BatchPCB] and will make it available on their market place once I verify that it works. |
| + | [* black] ~~I've ordered a prototype connector from [http://batchpcb.com/index.php/Home|BatchPCB] and will make it available on their market place once I verify that it works.~~ |
| + | [* black] Update: You can now get the connector [http://www.batchpcb.com/index.php/Products/65727|here] from BatchPCB. It's $2.50 but there is a $10 per order set up charge from them so you might also want to order the [http://www.batchpcb.com/index.php/Products/65726|PCB for the switch] at the same time. |