Alterações no passo nº 5
Edição por Brian —
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Next step will be to make the edge connector out of a scrap piece of PCB. | |
| [* black] I chose a section with ground plane on at least one side. It was sanded down to fit and scored to make 4 'traces'. | |
| + | [* black] The size of the traces almost matches a PCI connector. You might be able to scavenge a section from an old card. However, the traces leading away from the edge mus travel straight together for a while so you have enough room for the cable for connect to them. |
| + | [* black] I've ordered a prototype from [http://batchpcb.com/index.php/Home|BatchPCB] and will make it available on their market place once I verify that it works. |