Alterações no passo nº 5
Edição por Brian —
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Next step will be to make the edge connector out of a scrap piece of PCB. | |
| - | [* black] I chose a scetion of ground plane on at least one side. It was sanded down to fit and scored to make 4 'traces'. |
| + | [* black] I chose a scetion of ground plane on at least one side. It was sanded down to fit and scored to make 4 'traces'. This one pictured had a via in exactly the wrong place and it had to be drilled out. |