Alterações no passo nº 4
Edição por Brian —
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [* black] Here is the external connector to be rewired. It's attached with 4 #00 JIS screws and is not soldered to the pads on the logic board. |
|---|---|
| + | [* black] Rather than cutting traces and connecting directly to the pads, I covered them with a piece of Kapton and made new 'pads' with this strips of copper tape. There is a little IC that you will need to run over, but this part is very easy (and reversible). |
Imagem 1
Nenhuma imagem anterior
Adicionado
Imagem 2
Nenhuma imagem anterior
Adicionado
Imagem 3
Nenhuma imagem anterior
Adicionado