Alterações no passo nº 1
Edição por Alstein Einbert —
Edição recusada por Spencer Pennington
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* red] Remove the nine 6.3 mm black JIS screws from the lower case. | |
| - | [* icon_caution] Apply constant, downward pressure to avoid stripping these screws. You can use a Phillips #00 screwdriver, but make sure the head is aligned correctly to avoid damaging the screw. |
| + | [* icon_caution] To avoid stripping these screws, make sure you are using a JIS #00 screwdriver and ***not*** a PHILLIPS #00. You ''can" use a PHILLIPS #00 with a lot of downwards pressure but be warned this will deform the screw head and you risk stripping it. |
| + | [* black] Before editing this guide with misguiding information ''again'', please try the following. Get a product with untouched fresh JIS #00 screws. Use a JIS #00 screwdriver and notice the very little downforce needed and the fact the screw is intact afterward. Now use a PHILLIPS #00 and see the difference. You don't use a flathead for a hex screw. |
| [* orange] Remove the 2.4 mm silver JIS screw above the game cartridge slot. |