Conserte seus objetos Comunidade Loja

Alterações no passo nº 1

Edição por Spencer Day —

Edição aprovada por Spencer Day

Antes
Depois
Sem alteração

Linhas do passo

[* red] Unscrew the four JIS #00 screws along the top of the back cover.
[* icon_note] The screws are held in place by locking washers, and will not come out of the back cover.
-[* icon_caution] The comments section is full of unlucky souls who will tell you that the screws here through step 4 will strip, Phillips is not the same as JIS. If you dont want to buy a JIS Screwdriver, you can press down fairly hard with a Phillips #00 screwdriver. Be warned that this will mangle the screw and you risk stripping it!
+[* icon_caution] Apply constant, downward pressure to avoid stripping these screws. You can use a Phillips #00 screwdriver, but make sure the head is aligned correctly to avoid damaging the screw.