Skip to main content

Alterações no passo #4

Edição por Sam Goldheart

Edição aprovada by Sam Goldheart

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Temporarily puticon_note] In order to remove the LCD back intofront panel assembly, the body ofribbon cable needs to slide out between the iPad 2case and the LCD. You'll need to move the LCD to make some room.
[* icon_caution] Be very careful when moving the LCD, and do not attempt to
remove it from the iPad—its cable will remain connected while it is rotated over.
[* black] Lift the LCD from its long edge farthest from the digitizer cable and gently flip it toward the rear case—like closing a book.
[* black] While holding the LCD up, gently slide
the front panel, beingpanel away from the iPad. Be careful not to damagesnag the digitizer cable inon the processrear case or LCD.
[* black] Set the LCD back into the body for safekeeping
.
[* black] Temporarily puticon_note] In order to remove the LCD back intofront panel assembly, the body ofribbon cable needs to slide out between the iPad 2case and the LCD. You'll need to move the LCD to make some room.
[* icon_caution] Be very careful when moving the LCD, and do not attempt to
remove it from the iPad—its cable will remain connected while it is rotated over.
[* black] Lift the LCD from its long edge farthest from the digitizer cable and gently flip it toward the rear case—like closing a book.
[* black] While holding the LCD up, gently slide
the front panel, beingpanel away from the iPad. Be careful not to damagesnag the digitizer cable inon the processrear case or LCD.
[* black] Set the LCD back into the body for safekeeping
.

Imagem 1

Versão Antiga

Nova Versão

Imagem 2

Nenhuma imagem anterior

Adicionado