Menu

Suas configurações

Alterações no passo #6

Edição por Phil Bancroft —

Aguardando aprovação

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Disconnect the three antenna cables from the Airport card. There may be a square foam piece over the logic board connector.
[* icon_note] Disconnect the inverter cable from the socket by inserting thea spudger between the right or left edge of the plug and the socket, andsocket & prying gently upward. Be very careful. The top 1/2 of the connector/black cube is the plug- & the bottom 1/2 is the socket- fixed to the board. Find the join between plug and socket halfway up the black cube and lift up just the plug (top half) not the whole black cube- or you'll rip the socket & plug from the board.The inverter plug lifts vertically up off ofthe socket on the circuit board. Do notDon't pull it in the direction of the connecting wires or you willyou'll tear the socket off.
[* icon_note] Disconnect the inverter cable from the socket by inserting thea spudger between the right or left edge of the plug and the socket, andsocket & prying gently upward. Be very careful. The top 1/2 of the connector/black cube is the plug- & the bottom 1/2 is the socket- fixed to the board. Find the join between plug and socket halfway up the black cube and lift up just the plug (top half) not the whole black cube- or you'll rip the socket & plug from the board.The inverter plug lifts vertically up off ofthe socket on the circuit board. Do notDon't pull it in the direction of the connecting wires or you willyou'll tear the socket off.
[* icon_note] If you have a MacBook Core 2 Duo Santa Rosa/Penryn, there are only two antenna cables and the black inverter cable is in a different location.