Ir para o conteúdo principal

Alterações no passo #8

Edição por Andrew Optimus Goldheart

Edição aprovada por Andrew Optimus Goldheart

Antes
Depois
Sem alteração

Linhas de Passo

-[* black] Next we go for the internals of the camera module. Again, just with the Torx.
-[* black] The camera itself is an 8 megapixel CMOS camera with a 1/3.2 inch sensor and an aperture of f 2.2.
-[* black] It is plugged into the pogo board with a simple connector and held in place with a soft double sided adhesive tape inside the plastic housing.
+[* black] Up next, the rear camera module. Maybe in the future, this will be an individually upgradeable component?
+[* black] The camera itself is an 8 megapixel CMOS camera with a 1/3.2 inch sensor and an aperture of ƒ2.2.
+[* black] This module is built just like the others: a plastic case around an off the shelf component, connected to a pogo interface board via a traditional flex and connector.
+ [* icon_note] So while Fairphone hasn't removed the flex and connector, they have moved them a bit farther away from DIY fixers—greatly simplifying component swap repairs.