Alterações no passo #4
Edição por Andrew Bookholt —
- Antes
- Depois
- Sem alteração
Linhas de Passo
| [* red] Remove the three 8.4 mm #1 Phillips screws securing the heat sink to the logic board. [* icon_note] Don't lose the springs held under each of the screws. [* black] [* icon_note] If the heat sink seems to be stuck, it may be helpful to gently pry it off the processor with a plastic spudger. Be careful not to break any surface mount components on the processor while prying. [* icon_caution] Be sure to clean off the old thermal paste and apply a new layer before you reinstall the heat sink. We have a [guide|744|guide] that makes it easy. |
| [* red] Remove the three 8.4 mm #1 Phillips screws securing the heat sink to the logic board. [* icon_note] Don't lose the springs held under each of the screws. [* black] [* icon_note] If the heat sink seems to be stuck, it may be helpful to gently pry it off the processor with a plastic spudger. Be careful not to break any surface mount components on the processor while prying. [* icon_caution] Be sure to clean off the old thermal paste and apply a new layer before you reinstall the heat sink. We have a [guide|744|guide] that makes it easy. |
Imagem 1
Versão Antiga
Nova Versão