Ir para o conteúdo principal

Alterações no passo #12

Edição por Dante Mazzanti

Edição aprovada por Dante Mazzanti

Antes
Depois
Sem alteração

Linhas de Passo

-[* red] Remove the single 1.3 mm Phillips screw set into the upper edge of the rear case.
-[* black] Remove the following two screws:
- [* orange] One 2.6 mm Phillips
- [* yellow] One 2.2 mm Phillips standoff
- [* icon_note] If you don't have the proper standoff bit for this screw, you can remove it with a small flathead screwdriver.
+[* black] Remove the following screws:
+ [* red] One 1.3 mm Phillips screw
+ [* orange] One 2.6 mm Phillips screw
+ [* yellow] One 2.2 mm Phillips standoff screw
+ [* icon_note] If you don't have the proper standoff bit for this screw, you can remove it with a small flathead screwdriver.