Conserte seus objetos Comunidade Loja

Alterações no passo nº 1

Edição por Luis Franco —

Edição aprovada por Luis Franco

Antes
Depois
Sem alteração

Linhas do passo

-[* red] Locate the Speaker in the upper left corner of the Housing.
-[* orange] Locate the Speaker Ribbon Connector directly below the Speaker.
-[* black] Use the Plastic Spudger to gently pry upwards on the Speaker's Ribbon Connector.
-[* yellow] Use the Plastic Spudger to gently pry upwards on the Speaker Housing. Note: The Speaker Housing is attached with adhesive, therefor some force is required.
+[* red] Locate the speaker in the upper left corner of the housing.
+[* orange] Locate the speaker ribbon connector directly below the speaker.
+[* black] Use the plastic spudger to gently pry upwards on the speaker's ribbon connector.
+[* yellow] Use the plastic spudger to gently pry upwards on the speaker housing. Note: The speaker housing is attached with adhesive, therefore, some force is required.