Pular para o conteúdo principal

Alterações no passo #2

Edição por Henry H

Edição aprovada por Henry H

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Plug inMake sure the machine is turned off and turn on the Baristaunplugged.
[* black] PlaceSet your voltmeter in continuity mode and place the leads on the two 90 degree prongs on the boilerboiler's heating element.
[* black] Note: It does not matter which prongslead touches which prong as you're just testing for a break, or "open" in the voltmeter leads touch. A non-zero reading is all that's importantheating element circuit.
[* black] If there is no reading on the voltmetervoltmeter shows 0, or "open", then there is an issue with the boiler's continuity. Itheating element's continuity and it needs to be replaced.
[* black] Plug inMake sure the machine is turned off and turn on the Baristaunplugged.
[* black] PlaceSet your voltmeter in continuity mode and place the leads on the two 90 degree prongs on the boilerboiler's heating element.
[* black] Note: It does not matter which prongslead touches which prong as you're just testing for a break, or "open" in the voltmeter leads touch. A non-zero reading is all that's importantheating element circuit.
[* black] If there is no reading on the voltmetervoltmeter shows 0, or "open", then there is an issue with the boiler's continuity. Itheating element's continuity and it needs to be replaced.
[* black] If given a reading, then proceed to step 3.