Ir para o conteúdo principal

Alterações no passo nº 2

Edição por Lauren

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas do passo

-[* red] Now remove (4) 2.9mm screws from the L-shaped circuit board. They are marked with red circles in the slide.
-[* yellow] Then remove the (3) wire strips connected to the camera so you can pull off the L-shaped circuit board. They are marked with yellow boxes in the slide.
-[* orange] Next remove the one wire strip that is connected to the bottom of the circuit board.
+[* red] Remove (4) 2.9mm screws from the L-shaped circuit board. They are marked with red circles in the slide.
+[* yellow] Remove the (3) wire strips connected to the camera so you can pull off the L-shaped circuit board.
+[* orange] Remove the one wire strip that is connected to the bottom of the circuit board.