Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #3

Edição por Adam O'Camb

Edição aprovada de Adam O'Camb

Antes
Depois
Sem alteração

Linhas de Passo

[* icon_note] The following steps involve using an openingblack] Slide the pick to separatealong the rear panel frombottom edge of the midframe. Ifphone to slice through the adhesive is too strong, reapply heat withsecuring the iOpenerrear glass.
[* black] Usingicon_note] Afterward, it may help to leave the suction cup, apply pressurepick in place and grab a second pick as you proceed to the middle section ofnext step. Leaving the panel while pulling uppick inserted can help prevent the lower edge by pivoting your wristglue you just separated from re-adhering.
[* icon_note] Re-heat the rear glass as needed to prevent the glue from cooling and hardening
.
[* icon_note] The following steps involve using an openingblack] Slide the pick to separatealong the rear panel frombottom edge of the midframe. Ifphone to slice through the adhesive is too strong, reapply heat withsecuring the iOpenerrear glass.
[* black] Usingicon_note] Afterward, it may help to leave the suction cup, apply pressurepick in place and grab a second pick as you proceed to the middle section ofnext step. Leaving the panel while pulling uppick inserted can help prevent the lower edge by pivoting your wristglue you just separated from re-adhering.
[* icon_note] Re-heat the rear glass as needed to prevent the glue from cooling and hardening
.

Imagem 1

Versão Antiga

Nova Versão

Imagem 2

Versão Antiga

Nova Versão