Ir para o conteúdo principal

Alterações no passo #3

Edição por Philip Le Riche

Edição aprovada por Philip Le Riche

Antes
Depois
Sem alteração

Linhas de Passo

[* black] ThinWith the image sensor plate removed, three tiny springs will be seen in the lens back plate. These are very easily lost. Remove them with fine tweezers and put them somewhere safe.
[* black] A very thin coated
glass window. Don't remove unless needs cleaningwindow will fall out if the lens is inverted. On no account touch it with your fingers. It may be cleaned if necessary, however this is unlikely as the rear face is sealed from dust except during disassembly and the front face is normally protected by the focussing lens in its rest position.
[* black] Reassembly:The image sensor itself should not need cleaning unless contaminated while disassembled. Should it be necessary, first peel off the rubber bit, 3 springs, replacesurround. On reassembly, do not attempt to reattach this to the image sensor plate with 3 screwsbut rather place it over and around the glass window.
[* black] ThinWith the image sensor plate removed, three tiny springs will be seen in the lens back plate. These are very easily lost. Remove them with fine tweezers and put them somewhere safe.
[* black] A very thin coated
glass window. Don't remove unless needs cleaningwindow will fall out if the lens is inverted. On no account touch it with your fingers. It may be cleaned if necessary, however this is unlikely as the rear face is sealed from dust except during disassembly and the front face is normally protected by the focussing lens in its rest position.
[* black] Reassembly:The image sensor itself should not need cleaning unless contaminated while disassembled. Should it be necessary, first peel off the rubber bit, 3 springs, replacesurround. On reassembly, do not attempt to reattach this to the image sensor plate with 3 screwsbut rather place it over and around the glass window.

Imagem 1

Nenhuma imagem anterior

Adicionado