Ir para o conteúdo principal

Alterações no passo #7

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Clean the printhead
-[* icon_caution] ***''Do not use alcohol unless you are out of options. This may damage the printhead! Purge the printhead 3 times if alcohol is used to avoid problems.''***
-[* icon_note] ***''Recommended circulation times:''*** ***Alcohol:*** 5-10 minutes. ***Without alcohol:*** 15 minutes.
-[* icon_note] The water will get lighter as the ink breaks down. ***''An ultrasonic cleaner can be used on stubborn clogs.''***
-[* red] Pour hot water into a bowl and let the printhead sit. Change the water until the printhead is reasonably clean.
-[* orange] Dry the printhead contacts and nozzles by hand to ensure these areas are dry.
-[* yellow] Before reinstalling the printhead, let it air dry for ~3-4 hours. ***''Use a fan to reduce the dry time.''***
+[* icon_caution] ***''Only use alcohol as a final option. It may damage the printhead seals! IF USED, FLUSH WITH CLEAN WATER 3 TIMES.''***
+[* icon_reminder] ***''Recommended circulation times:''*** ***Alcohol:*** 5-10 minutes. ***Without alcohol:*** 15 minutes.
+[* icon_note] The water will get lighter as the ink breaks down. ***''An ultrasonic cleaner may help with stubborn clogging.''***
+[* red] Put the printhead in hot water. Let it sit until it is reasonably clean. ***''Change the water as it turns black.''***
+[* orange] ***''Wipe down the printhead contacts and nozzles by hand to ensure these areas are dry.''***
+[* yellow] Before reinstalling the printhead, let it air dry for ~3-4 hours. ***''Using a fan may speed this step up.''***