Ir para o conteúdo principal

Alterações no passo #7

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Clean the printhead
-[* icon_caution] Alcohol should only be used as a last resort as it can damage the printhead. ***''Purge the printhead 3 times if alcohol is used.''***
+[* icon_caution] ***''Do not use alcohol unless you are out of options. This may damage the printhead! Purge the printhead 3 times if alcohol is used to avoid problems.''***
[* icon_note] ***''Recommended circulation times:''*** ***Alcohol:*** 5-10 minutes. ***Without alcohol:*** 15 minutes.
-[* icon_note] The water will get lighter as the ink breaks down. Change the water frequently. ***''An ultrasonic cleaner or paintbrush can be used for stubborn clogs.''***
-[* red] Pour hot water into a bowl and let the printhead sit. Change the water as it gets dark until it is reasonably clean.
+[* icon_note] The water will get lighter as the ink breaks down. ***''An ultrasonic cleaner can be used on stubborn clogs.''***
+[* red] Pour hot water into a bowl and let the printhead sit. Change the water until the printhead is reasonably clean.
[* orange] Dry the printhead contacts and nozzles by hand to ensure these areas are dry.
-[* yellow] Before reinstalling the printhead, let it air dry for ~2-3 hours. ***''Tip: Use a fan to reduce the air dry time.''***
+[* yellow] Before reinstalling the printhead, let it air dry for ~3-4 hours. ***''Use a fan to reduce the dry time.''***