Ir para o conteúdo principal

Alterações no passo #7

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Clean the printhead
[* icon_caution] Alcohol should only be used as a last resort as it can damage the printhead. ***''Purge the printhead 3 times if alcohol is used.''***
-[* icon_caution] ***''Recommended circulation times:''*** ***Alcohol:*** 5-10 minutes. ***Without alcohol:*** 15 minutes.
-[* icon_reminder] The water will get lighter as the ink is cleared from the printhead. Change the water until it is clear. ***''For stubborn clogs, a ultrasonic cleaner or paintbrush can help break clogs down.''***
-[* red] Pour hot water into a bowl and let the printhead sit. Change the water as it gets dark and unusable. Do this until the water is reasonably clear.
-[* orange] To mitigate ***Printhead Problem*** errors, dry the contacts and nozzles by hand.
-[* yellow] Before reinstalling the printhead, let it dry for ~2-3 hours outside of the printer. ***Tip:*** Put the printhead in front of a fan to speed this up.
+[* icon_note] ***''Recommended circulation times:''*** ***Alcohol:*** 5-10 minutes. ***Without alcohol:*** 15 minutes.
+[* icon_note] The water will get lighter as the ink breaks down. Change the water frequently. ***''An ultrasonic cleaner or paintbrush can be used for stubborn clogs.''***
+[* red] Pour hot water into a bowl and let the printhead sit. Change the water as it gets dark until it is reasonably clean.
+[* orange] Dry the printhead contacts and nozzles by hand to ensure these areas are dry.
+[* yellow] Before reinstalling the printhead, let it air dry for ~2-3 hours. ***''Tip: Use a fan to reduce the air dry time.''***