Ir para o conteúdo principal

Alterações no passo #7

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Clean the printhead
[* icon_caution] Alcohol should only be used as a last resort since it can damage the printhead. If alcohol is used, purge the printhead with clean water ***THREE TIMES***.
-[* icon_reminder] The water will get lighter as the ink is cleared from the printhead. As such, you will need to do this multiple times. ***Tip:*** Stubborn clogs that do not clear easily may come out if an ultrasonic cleaner or paintbrush is used.
-[* icon_note] Put the printhead in front of a fan to speed up the drying time.
-[* icon_note] ***Recommended circulation times:*** ***With alcohol:*** 5-10 minutes. ***Without alcohol:*** 15 minutes.
+[* icon_caution] ***Recommended circulation times:*** ***With alcohol:*** 5-10 minutes. ***Without alcohol:*** 15 minutes.
+[* icon_reminder] The water will get lighter as the ink is cleared from the printhead. Change the water until it is clear. ***Tip:*** For stubborn clogs, an ultrasonic cleaner or paintbrush may help break the clog down.
[* red] Pour hot water into a bowl and let the printhead sit. Change the water as it gets dark and unusable. Do this until the water is reasonably clear.
[* orange] To mitigate ***Printhead Problem*** errors, dry the contacts and nozzles by hand.
-[* yellow] Before reinstalling the printhead, let it dry for ~2-3 hours outside of the printer.
+[* yellow] Before reinstalling the printhead, let it dry for ~2-3 hours outside of the printer. Before reinstalling the printhead, let it dry for ~2-3 hours outside of the printer. ***Tip:*** If you want to speed up the drying time, put the printhead in front of a fan.