Ir para o conteúdo principal

Alterações no passo #7

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Clean the printhead
[* icon_caution] Alcohol should only be used as a last resort since it can damage the printhead. If alcohol is used, purge the printhead with clean water ***THREE TIMES***.
[* icon_note] As the ink clears up, the ink should get progressively lighter. This will take multiple cycles on heavily clogged printers. ***Tip: If your printer has a stubborn clog, an ultrasonic cleaner or small paintbrush can help with these clogs.***
[* icon_note] Put the printhead in front of a fan to speed up the drying time.
[* icon_reminder] ***Recommended circulation times:*** ***With alcohol:*** 5-10 minutes. ***Without alcohol:*** 15 minutes.
[* black] Pour hot water into a bowl and let the printhead sit. As the water gets dirty, change it out. Once the water is reasonably clear, the printhead is clean.
[* black] Remove the printhead and dry the nozzles and electrical contacts by hand. This will help mitigate the ***Printhead problem*** error.
-[* black] While the printhead is likely ready to use, allow the printhead to dry before installation. Let it sit outside of the printhead for ~2-3 hours before installation.
+[* black] While the printhead is likely ready to use, allow the printhead to dry before installation. Let the printhead dry outside the printer for ~2-3 hours.