Alterações no passo #3
Edição por R Trent —
- Antes
- Depois
- Sem alteração
Linhas de Passo
[* black] Holding the drive top up, gently pull the top half up from the bottom half. The back will rotate up as the front is connected by two plastic clips. |
[* red] These clips are most easily undone by rotating the top enclosure to about 30º then lifting it up firmly. |
[* icon_note] Be careful to not let it jerk violently during separation. Once the top is removed, there isn't much of anything holding the latch assembly in place. It would be a bummer to lose the spring, though getting the latch assembly back in place if it comes out is not too difficult, just don't lose the spring. |
Imagem 1
Nenhuma imagem anterior
Adicionado
Imagem 2
Nenhuma imagem anterior
Adicionado
Imagem 3
Nenhuma imagem anterior
Adicionado