Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #1

Edição por R Trent

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

[* black] Here it is. The standard 20GB HDD for the Xbox 360.
[* red] Notice the proprietary adapter. Inside is just a pretty standard 2.5" SATA drive...
[* orange] I took these pictures as I was putting it back together, hence the Microsoft warranty sticker looking a little funny.
[* yellow] You may also notice the screw in the bottom left is partly out. This is because as I was replacing the screw before it, I broke my bit. I was using a 1/16" flathead bit (I don't have a T6 Torx) and used just a little too much torquetorque and it snapped. I found another 1/16" bit to finish, but didn't get a pic.
[* icon_reminder] If you have Torx bits/drivers, use them. They will work much better than the flatheads.
[* yellow] You may also notice the screw in the bottom left is partly out. This is because as I was replacing the screw before it, I broke my bit. I was using a 1/16" flathead bit (I don't have a T6 Torx) and used just a little too much torquetorque and it snapped. I found another 1/16" bit to finish, but didn't get a pic.
[* icon_reminder] If you have Torx bits/drivers, use them. They will work much better than the flatheads.