Alterações no passo nº 2
Edição por anonymous —
Edição aprovada por Evan Noronha
- Antes
- Depois
- Sem alteração
Linhas do passo
- | [* black] Use a spudger to gently pry the rear-facing camera up and out of the device. |
---|---|
- | [* icon_note] There is some adhesive securing the rear-facing camera, so extra force may be required. |
- | [* icon_note] The motherboard is not shown in the first image, but it is ***not*** necessary to remove it in order to replace the rear-facing camera. |
+ | [* black] Use a spudger to gently pry the rear-facing camera up to dislodge it from the adhesive. |
+ | [* icon_note] There is some adhesive securing the rear-facing camera to bottom and sides of its grey housing. |
+ | [* black] Pull the camera laterally towards its ribbon to reveal the circuit board hiding under the motherboard. |
+ | [* icon_caution] Don't pull upwards until you can see the black circuit board of the camera fixture (seen in the second image). |
+ | [* black] Once you can see all of the camera fixture, you can pull up and remove it. |
+ | [* icon_note] The motherboard is not shown in the first image, but it is ***not*** necessary to remove it in order to replace the rear-facing camera. |