Ir para o conteúdo principal

Alterações no passo #12

Edição por William McNamara

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

[* red] Use a small flathead screwdriver to remove the 4.8 mm standoff near the headphone jack.
[* icon_note] When reassembling the device, this standoff sets the height of the wi-fi shield removed in step 14. If not torqued down, the shield will be above the plane of the frame and the back will not slide into place in step 2. The shield should be flush with the headphone jack.
+[* black] When reassembling the motherboard, ensure that its edge sits under the circled standoff, otherwise the screws will not fit.