Ir para o conteúdo principal

Alterações no passo #7

Edição por Dennis Jengo

Edição recusada por David Hodson

Antes
Depois
Sem alteração

Linhas de Passo

[* black] Remove the following five screws securing the Wi-Fi antenna to to the logic board:
- [* red] One 2.3 mm Phillips
- [* orange] Two 1.6 mm Phillips
- [* yellow] One 1.4 mm Phillips
- [* green] One 4.8 mm Phillips
+ [* red] One 2.3 mm Phillips*** screw #7***
+ [* orange] Two 1.6 mm Phillips*** screws #8,9***
+ [* yellow] One 1.4 mm Phillips*** screw #10***
+ [* green] One 4.8 mm Phillips*** screw #11***
[* icon_caution] When re-assembling, start off with replacing the 4.8 mm Philips screw first, then the 2.3 mm. ''This is to ensure there is no mix-up, and avoid rendering the LCD and digitizer useless.''
[* icon_caution] Also make sure to put the long 4.8 mm Philips back in correctly when reassembling. This is the ground for the Wi-Fi antenna and is often the culprit if you are having bad Wi-Fi reception after reassembly.