Ir para o conteúdo principal

Alterações no passo #5

Edição por David Hodson

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

[* black] Continue to push the logic board assembly through the outer case of the iPod with a spudger.
[* icon_note] Tolerances inside the Nano are extremely tight. Be very patient and go slowly when removing the logic board assembly, and make sure no components or ribbon cables get caught on the case.
-[* icon_note] To make sure that the hold switch does not catch on the housing of the iPod and tear the cable, feed the switch straight down the center of the device, where the opening is the widest.
+[* icon_note] To make sure that the hold switch plate does not catch on the housing of the iPod and tear the cable, feed the switch straight down the center of the device, where the opening is the widest.