Pular para o conteúdo principal

Alterações no passo #4

Edição por David Hodson

Aguardando aprovação

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* icon_note] The battery on the Nano is attached via solder pads with small holes that go through the battery ribbon cable and attach to flat pads on the face of the logic board. In the following stepsthis step, you will heat each solder pad individually while using a metal spudger to pry it up from the logic board.
[* icon_note] The battery on the Nano is attached via solder pads with small holes that go through the battery ribbon cable and attach to flat pads on the face of the logic board. In the following stepsthis step, you will heat each solder pad individually while using a metal spudger to pry it up from the logic board.
[* icon_caution] '''DO NOT''' bridge the connection between the solder pads both on the board and on the ribbon cable with your spudger. Shorts have the potential to ruin the logic board.
[* icon_caution] Beware of overheating the board and the cable. Only hold the tip of the iron against the pad long enough to let the solder melt. Excess heat buildup has the potential to ruin the logic board or melt the ribbon cable.
[* black] Start working from one side of the battery ribbon cable. In our case, we started on the right. Heat the rightmost solder pad while gently prying up from under the ribbon cable to free it from the board.