Alterações no passo nº 1
Edição por S Davies —
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* icon_note] In the following steps, you will use a heat gun to soften the adhesive securing the outer black border around the underside of the front glass panel to the inner case. | |
| - | [* black] With the heat gun set to low, start by heating the outer black border near the upper left corner of the glass panel. |
| + | [* black] With the heat gun set to low, start by heating the outer black border near the upper left corner of the glass panel. Note: the underside, glass, and other metal parts will be hot to the touch. Be careful while handling! |
| [* black] Try not to excessively heat the outer plastic edge of the Evo. | |
| [* icon_note] Due to the heat applied, it is normal for a layer of condensation to develop on the inside of the glass panel and/or the outside of the LCD. It can be removed with glass cleaner once the glass is separated from the display. |