Conserte seus objetos Comunidade Loja

Alterações no passo nº 1

Edição por Walter Galan —

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas do passo

-[* black] Insert wisdom here.
+[* icon_note] In the following steps, you will use a heat gun to soften the adhesive securing the outer black border around the underside of the front glass panel to the inner case.
+[* black] With the heat gun set to low, start by heating the outer black border near the upper left corner of the glass panel.
+[* icon_caution] Always aim the heat gun away from the soft rubber strip around the display glass. Heating the rubber will cause it to melt slightly, turning its finish from matte to glossy. Touching overheated rubber can cause it to permanently deform.
+[* icon_note] Due to the heat applied, it is normal for a layer of condensation to develop on the inside of the glass panel and/or the outside of the LCD. It can be removed with glass cleaner once the glass is separated from the display.