Alterações no passo nº 4
Edição por Richdave —
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* green] Disconnect the upper fan connector from the logic board | |
| [* red] Remove the 4 spring loaded screws holding the heat sink assembly to the logic board | |
| + | [* icon_note] When reassembling, thread all screws in a1 -1 1/2 turns then alternately tighten each screw 1 turn - starting top left, then bottom right, then bottom left, then top left again etc. until the heat sink assembly is firmly seated and all screws are tightened the same amount. |