Conserte seus objetos Comunidade Loja

Alterações no passo nº 4

Edição por Jacob Pugsley —

Edição aprovada por Jacob Pugsley

Antes
Depois
Sem alteração

Linhas do passo

[* red] Disconnect the upper fan connector from the motherboard.
-[* orange] Remove the 4 spring loaded screws holding the heat sink assembly to the motherboard.
-[* icon_note] When reassembling, thread all screws in 1 - 1 1/2 turns then alternately tighten each screw 1 turn - starting top left, then bottom right, then bottom left, then top right, then top left again etc. until the heat sink assembly is firmly seated and all screws are tightened the same amount.
+[* orange] Remove the four spring loaded screws holding the heat sink assembly to the motherboard.
+[* icon_note] When reassembling, ensure that all the screws are equally tightened: thread all screws one turn, then add one turn to each screw in the following order: top left, bottom right, bottom left, top right. Repeat this order until the assembly is firmly seated.