Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #1

Edição por Adriana Rahrig

Edição aprovada por Geoff Wacker

Antes
Depois
Sem alteração

Linhas de Passo

[*title] Remove the hard drive
[* icon_reminder] HDD is an abbreviation for "hard disk drive."
[*
icon_note] Before removing the HDD, you need to remove the temperature sensor attached to it and keep it for installationthat is mounted directly on the new HDD.
[* red]
hard drive. The HDD temperature sensor is mounted directly onattached to the hard drive,drive using adhesive tape and a protective foam cushion.
[* black] Carefully peel

[* red] Peel
off the foam and set the sensor aside. Be gentle with the foam, sincefoam because you will need to reuse it to connect the heat sensor to the new HDD.
[* blue] Lift the HDD out carefully,of the device and disconnect the two SATA cables from the drive.
[* icon_note] Replace the heat sensor in about the same position on your new
HDD. Make sure the flat surface of the sensor is flat against the metal hard drive enclosure, and add some adhesive tape to the foam (if necessary) to keep it in place.
[*title] Remove the hard drive
[* icon_reminder] HDD is an abbreviation for "hard disk drive."
[*
icon_note] Before removing the HDD, you need to remove the temperature sensor attached to it and keep it for installationthat is mounted directly on the new HDD.
[* red]
hard drive. The HDD temperature sensor is mounted directly onattached to the hard drive,drive using adhesive tape and a protective foam cushion.
[* black] Carefully peel

[* red] Peel
off the foam and set the sensor aside. Be gentle with the foam, sincefoam because you will need to reuse it to connect the heat sensor to the new HDD.
[* blue] Lift the HDD out carefully,of the device and disconnect the two SATA cables from the drive.
[* icon_note] Replace the heat sensor in about the same position on your new
HDD. Make sure the flat surface of the sensor is flat against the metal hard drive enclosure, and add some adhesive tape to the foam (if necessary) to keep it in place.