Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #1

Edição por Richdave

Edição aprovada por Richdave

Antes
Depois
Sem alteração

Linhas de Passo

[* icon_note] Before removing the HDD you need to remove the temperature sensor attached to it and keep it for installation on the new HDD
[* red] The HDD temperature sensor is mounted directly on the hard drive using adhesive tape and a protective foam cushion.
[* black] Carefully peel the foam off and set the sensor aside. Be gentle with the foam, since you will need to reuse it to connect the heat sensor to the new HDD.
[* blue] Lift the HDD out carefully, and disconnect the two SATA cables from the drive.
[* icon_note] Replace the heat sensor in about the same position on your new HDD. Make sure the flat surface of the sensor is flat against the metal hard drive enclosure, and add some adhesive tape to the foam if necessary to keep it in place.