Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #1

Edição por bushing

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

[* red] On the HDD itself thereThe HDD temperature sensor is mounted directly on the hard drive using adhesive tape and a heat sensorprotective foam cushion.
[* black] Carefully peel the foam offoff and set the sensor aside. Be gentle with the foam, since you will need to reuse it to connect the heat sensor to the new HDD.
[* blackblue] Lift the HDD out carefully, and disconnect the cablestwo SATA cables from the drive.
[* icon_note] Replace the heat sensor in about the same position on your new HDD. Make sure the flat surface of the sensor is flat against the metal hard drive enclosure, and add some adhesive tape to the foam if necessary to keep it in place.
[* red] On the HDD itself thereThe HDD temperature sensor is mounted directly on the hard drive using adhesive tape and a heat sensorprotective foam cushion.
[* black] Carefully peel the foam offoff and set the sensor aside. Be gentle with the foam, since you will need to reuse it to connect the heat sensor to the new HDD.
[* blackblue] Lift the HDD out carefully, and disconnect the cablestwo SATA cables from the drive.
[* icon_note] Replace the heat sensor in about the same position on your new HDD. Make sure the flat surface of the sensor is flat against the metal hard drive enclosure, and add some adhesive tape to the foam if necessary to keep it in place.

Imagem 3

Versão Antiga

Nova Versão