Ir para o conteúdo principal

Alterações no passo #9

Edição por Jeff Suovanen

Edição aprovada por Jeff Suovanen

Antes
Depois
Sem alteração

Linhas de Passo

-[* black] Repeat this procedure with the next battery cell in.
-[* black] Push the card about an inch between the battery cell and the upper case, and slowly pry the cell up to separate all of the adhesive.
+[* black] Repeat this procedure with the adjacent battery cell:
+ [* black] Apply a small amount (about 1 ml) of liquid adhesive remover under the battery cell, and wait 2-3 minutes for it to penetrate and soften the adhesive.
+ [* black] Alternatively, re-heat this section with your iOpener if needed.
+ [* black] Push a plastic card about an inch between the battery cell and the upper case, and slowly pry the cell up to separate all of the adhesive.