Ir para o conteúdo principal

Alterações no passo #16

Edição por Jeff Suovanen

Edição aprovada por Jeff Suovanen

Antes
Depois
Sem alteração

Linhas de Passo

+[* black] Remove the battery.
+[* icon_reminder] Before installing your new battery, remove all the old adhesive from the MacBook Pro's case.
+ [* black] With a little luck, you can slowly pull out each strip of adhesive with your fingers.
+ [* black] Otherwise, soak each section of adhesive with a bit of adhesive remover for 2-3 minutes, and then scrape it out with an opening pick or one of the other tools in your kit. This can take quite a bit of work, so be patient.
+ [* black] Mop up any remaining adhesive remover and give your MacBook Pro a few minutes to air dry.
+[* icon_reminder] The replacement battery included in your iFixit kit comes with adhesive pre-installed. One cell at a time, peel off the film covering the adhesive, and carefully position the battery cell before pressing it into place.
+[* black] Calibrate your battery before using it: allow it to drain overnight, then charge it to 100% and drain it again until your MacBook Pro shuts down automatically. Charge it again and use it normally.
+[* icon_caution] If you notice any unusual behavior or problems after installing your new battery, you may need to [https://support.apple.com/en-gb/HT201295|reset your MacBook Pro's SMC|new_window=true].

Imagem 1

Nenhuma imagem anterior

Adicionado

Imagem 2

Nenhuma imagem anterior

Adicionado