Ir para o conteúdo principal

Alterações no passo #4

Edição por Jeff Suovanen

Edição aprovada por Jeff Suovanen

Sem alteração

Linhas de Passo

-[* black] Open your container of adhesive remover.
-[* black] Fill the syringe included in your kit with a small amount (approximately 1-2 milliliters) of adhesive remover.
- [* icon_note] It's best to fill the syringe with no more than about 1-2 milliliters of adhesive remover at a time, so as to avoid accidentally applying too much.
- [* black] Refill your syringe as needed throughout the rest of this procedure.
+[* black] Pull off the black rubber stopper from your bottle of adhesive remover.
+[* icon_caution] Twist to loosen or remove the bottle cap before you cut the applicator tip.
+ [* icon_note] This unseals the bottle and allows the pressure to equalize before you cut the applicator tip. ***If you skip this step, the adhesive remover may spray out unexpectedly when the tip is cut.***
+[* black] Use scissors to cut off the sealed tip of the applicator.
+ [* icon_note] Cutting close to the narrow tip will give you better control so you can apply the adhesive remover in small amounts.
+[* icon_caution] Twist and close the bottle cap securely before you proceed further.

Imagem 1

Versão Antiga

Nova Versão

Imagem 2

Versão Antiga

Nova Versão

Imagem 3

Nenhuma imagem anterior