Alterações no passo nº 6
Edição por Carsten Frauenheim —
Edição aprovada por Carsten Frauenheim
- Antes
- Depois
- Sem alteração
Linhas do passo
| [title] Press Connectors | |
| [* icon_note] Smaller press-fit (or "pop") connectors may require a simple flick with a plastic opening tool, spudger, or fingernail. | |
| [* black] Place the tip of your tool under the edge of the connector, and pry the connector straight up from its socket. | |
| [* icon_caution] Be very careful to pry ***only*** under the edge of the connector, and not under the socket itself. If you pry under the socket, you will separate it from the circuit board, which requires specialized microsoldering skills and equipment to repair. | |
| [* icon_reminder] To reconnect, align the connector carefully over its socket and press down with your fingertip—first at one side, then the other—until it clicks into place. | |
| - | [* icon_caution] ***Do not*** press down on the middle until |
| + | [* icon_caution] ***Do not*** press down on the middle of wider connectors until they're fully seated—if misaligned, the connector or the pins underneath can bend or break, causing permanent damage. |