Ir para o conteúdo principal

Alterações no passo #13

Edição por Jeff Suovanen

Edição aprovada por Jeff Suovanen

Antes
Depois
Sem alteração

Linhas de Passo

-[* black] Add 2 lengths of shrink-tube on the 2 wires
-[* black] Now, solder the 4 wires together
-[* icon_caution] Make sure to connect white to white, and black to the bear metalled one
-[* icon_note] Make sure to do this step really quickly, as the heat-shrink tube will contract from the heat of the soldering
-[* black] Alternatively, you could just use duct tape - just be careful it doesn't slide off when you're bending the wires
-[* black] Move the shirk-tube over the soldering spots, and heat it up (mine fell a bit short, so I did end up using a bit of duct tape)
+[* black] Add 2 lengths of shrink-tube on the 2 wires.
+[* black] Now, solder the 4 wires together.
+ [* icon_caution] Make sure to connect white to white, and black to the bare metal one.
+ [* icon_note] Make sure to do this step really quickly, as the heat-shrink tube will contract from the heat of the soldering.
+ [* black] Alternatively, you could just use duct tapejust be careful so it doesn't slide off when you're bending the wires.
+[* black] Move the shirk-tube over the soldering spots, and heat it up. (Mine fell a bit short, so I did end up using a bit of duct tape.)