Ir para o conteúdo principal

Alterações no passo #13

Edição por Darie H

Edição aprovada por Darie H

Antes
Depois
Sem alteração

Linhas de Passo

[* black] Add 2 lengths of shrink-tube on the 2 wires
[* black] Now, solder the 4 wires together
[* icon_caution] Make sure to connect white to white, and black to the bear metalled one
-[* icon_note] Make sure to do this step really quickly, as you your hear-shrink tube will contract from the heat of the soldering
+[* icon_note] Make sure to do this step really quickly, as the heat-shrink tube will contract from the heat of the soldering
[* black] Alternatively, you could just use duct tape - just be careful it doesn't slide off when you're bending the wires
[* black] Move the shirk-tube over the soldering spots, and heat it up (mine fell a bit short, so I did end up using a bit of duct tape)