Ir para o conteúdo principal

Alterações no passo #12

Edição por Jeff Suovanen

Edição aprovada por Jeff Suovanen

Antes
Depois
Sem alteração

Linhas de Passo

-[* black] Thread the rubber/plastic stopper back onto the wires
-[* icon_caution] Do this AFTER you have applied solder to the tips of the wires
-[* black] To do this, I sprayed a bit of alcohol on the whole thing, and pulled the wires with the pliers; it required a pretty decent amount of force - but don't worry, the cables should hold without a problem - just make sure you're pulling both at the same time
-[* red] Note that I've also added a tiny length of shrink-tube on the exposed wire
+[* black] Thread the rubber/plastic stopper back onto the wires.
+ [* icon_caution] Do this AFTER you have applied solder to the tips of the wires.
+ [* black] To do this, I sprayed a bit of alcohol on the whole thing, and pulled the wires with the pliers. It required a pretty decent amount of forcebut don't worry, the cables should hold without a problem. Just make sure you're pulling both at the same time.
+ [* red] Note that I've also added a tiny length of shrink-tube on the exposed wire.