Pular para o conteúdo principal

Alterações no passo #5

Edição por iRobot

Aguardando aprovação

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Use your thumbs to slide the RJ-11 telephone jackboard away from the sound card in the same direction you would if you were disconnecting the phonedisconnect a cable. The jack has two slots that cup the board so make sure that when you apply pressure to remove from the board you are pushing parallel to the board.
[* black]
This is your chance to get out some aggression, as the jackboard will most likely be very tight and requires a good deal of force to remove. Don't get carried away though - don't hold onto the power connector and don't put too much actual force on the card itself.
[* black] Use your thumbs to slide the RJ-11 telephone jackboard away from the sound card in the same direction you would if you were disconnecting the phonedisconnect a cable. The jack has two slots that cup the board so make sure that when you apply pressure to remove from the board you are pushing parallel to the board.
[* black]
This is your chance to get out some aggression, as the jackboard will most likely be very tight and requires a good deal of force to remove. Don't get carried away though - don't hold onto the power connector and don't put too much actual force on the card itself.