Skip to main content

Alterações no passo #9

Edição por iRobot

Aguardando aprovação

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Place enough pressure on the upper case to allow you to slide a tool just within the seam between upper case and lower case as shown in the picture. A dentist's hook, push pin, or similar tool will work.
[* icon_note] Do not yank the upper case off as soon as you free the clasp. The case is attached to the logic board via two ribbon cables.
[* black] Delicately slip the tip of your tool behind the silver metal latch and pull it forward while pulling up on the case. This may take some effort.

Imagem 1

Nenhuma imagem anterior

Adicionado