Conserte seus objetos Comunidade Loja

Alterações no passo nº 4

Edição por KaylaYoung —

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas do passo

-[* icon_caution] Be Extremely Careful in this next step as if you pry the hinge off too fast you may rip the connector between the logic board and screen.
-[* black] Carefully wedge a plastic opening tool between the hinge on the body as shown in the highlited area in picture two. (be sure to insert the wedge into the right hinge when looking down onto the phone as in the picture).
-[* black] Slowly pry the hinge off the body as shown in the third picture and set the phone down when you get to this step.
-[* black] Next slide the connector cable out of the slot on the back side of the phone and the screen will be disconnected from the key pad body.
+[* black] Carefully wedge a plastic opening tool between the hinge on the body as shown in the highlighted area in picture one. (be sure to insert the wedge into the right hinge when looking down onto the phone, as in the picture).
+[* black] Slowly pry the hinge off the body as shown being done in the second picture and set the phone down after done with this step. The phone may also be pried apart with your hands.
+[* black] Because you are replacing the display screen with a new one, it is ok if the connector strip tears because the new display screen will have its own connector strip.
+[* black] Next slide the connector cable out of the slot on the back side of the phone and the screen will be disconnected from the key pad body. (PICTURE)